The Midnight is a JFET-based phaser pedal that expands on traditional analog phaser design.

The intuitive user-interface includes mix, feedback, and depth controls to create a warm, analog phaser experience. The Midnight uses digital controls to offer five global waveforms for both tap and ramp modes.

Tap mode offers tap tempo functionality with four subdivisions. Ramp mode allows the user to set slow and fast phasing speeds and accelerate between the two, emulating a classic rotary speaker cabinet.

Continue →

● Analog JFET-based phaser with handpicked transistors that provide vintage phaser sounds.

● Intuitive interface with mix, feedback, depth, and mode controls for custom phaser tones.

● Tap mode with multiple sub-divisions to sync the phaser speed to the tempo of your song.

● Ramp mode alternates between two selectable phase speeds, creating endless phaser options.

● Smart switching system that provides standard on/off latching and momentary operation.

● Top-mounted instrument and power jacks to save pedal board space.

● Buffered-bypass design to optimize signal integrity with any instrument cable length.

Continue →

Version

2.0.

Circuit Design

Analog.

Output Audio

Mono.

Bypass Switching

Buffered bypass.

Switching Methods

Momentary or latching.

Power Supply

9VDC - 50mA (2.1mm - center negative).

Dimensions

2.6''x4.77'' (W x L).

Mix

Controls the overall mix of the signal.

Feedback

Controls the amount of signal fed back into the phaser.

Depth

Controls the depth of the phasing.

Tap and Ramp

Selects the mode of operation.

Continue →

Rate

Controls the rate of the phaser.

Divisions

Sets the tap tempo to one of the following divisions:

Whole, half, quarter, and eighth.

Control Switch

Sets the tempo.

Continue →

R.Time

Controls the amount of time to ramp between the slow and fast rate.

Slow (Fast)

Adjusts the slow and fast rate.

Changing the Slow and Fast Rates

1. Rotate the slow (fast) knob to adjust slow rate.

2. Hold on (hold) and rotate the slow (fast) knob to adjust fast rate.

Control Switch

Hold control to adjust the rate of the phaser from slow to fast. Release control to return the rate back to slow.

Continue →

Changing the Waveform

1. Hold on (hold).

2. Rotate the (waveform) knob to desired waveform.

3. Release on (hold) to finalize selection.

Continue →

On (Hold) Switch

Turns the effect on and off or when the effect is on, hold on (hold) to access (waveforms) and fast.

Latching Operation

1. Press and release on (hold) quickly to toggle the effect on and off.

2. When the effect is on, hold on (hold) to access (waveforms).

Momentary Operation

1. Hold on (hold) when effect is off to temporarily turn the effect on and release on (hold) to turn the effect off.